1. Sani baara ka kɛ, baarakɛla ka kan ka sanbaraw don minnu bɛ se ka don a kɔnɔ ani ka ganw don minnu tɛ se ka don u kɔnɔ ani lunɛti minnu bɛ u tanga. Minɛnw ka kan ka don dugukolo la ni dannaya ye.
2. Contact arcing method, ka kan ka fɔlɔ ka butɔni digi marifa kan, o kɔfɛ, nozzle bɛ teliya ka tigɛ tigɛda la kɔkili la, o min bɛ nafa sɔrɔ ka tɛmɛ arc tigɛ kan. ni arc ka gɛlɛn, fiɲɛ tansiyɔn bɛ se ka ladilan ka se duguma dan ma!
3. tansiyɔn dɔgɔyali dakun ni fiɲɛ komɛsi ka kan ka ji bɔ tuma bɛɛ, a tɛ se ka teliya kojugu ni a tigɛra, walasa ka a tanga sɔgɔli ni arc reflection ma min bɛ sɔrɔ kɔkili min bɛ se ka sɛgɛn, o tɛ tigɛ, o tɛ se ka tigɛ teliya kojugu, walasa kɔkili min bɛ se ka sɛgɛn, o ka kɛ bilen ye, o bɛ nɔ bila tigɛcogo ɲuman na ni tigɛyɔrɔ ka kan ka bɔ fɔlɔ, ani o kɔfɛ, tigɛyɔrɔ ka kan ka wuli ka taa a nɔ na. Electrode nozzle.
4. When cutting, always pay attention to the use of air pressure, voltage, electrode and nozzle. Do not spray the copper after the wire in the electrode is used to cause the electrode and the contact tip to short-circuit and burn the torch. The filaments in each electrode are about 3 mm long. When the nozzle aperture is increased, the cutting quality and thickness will be seriously reduced, and the nozzle should be replaced o yɔrɔnin bɛɛ!
5. Ni slan deflection sɔrɔla ko a ka jugu, a lajɛ ni nozzle spout jiginna ka tɛmɛ. n’o tɛ a bɛ nozzle ni elekitorode bila. a ka kan ka kɔlɔsi ko tigɛyɔrɔ gɛlɛya bɛ tali kɛ tigɛlan sanfɛla la Ni sɛbɛn in sanfɛla ka gɛlɛn ani a nɔgɔlen don, ni tigɛ lamagacogo tɛ kelen ye, tigɛ ka bon ani a sanfɛla cogoya bɛ tiɲɛ kosɛbɛ.
6. Electrode ni nozzle ka baarakɛ waati bɛ tali kɛ plati bonya la ani baarakɛcogo fɛɛrɛ. cogo la min bɛ kɛ cogo la min bɛ bɛn, elekitorode kelen-kelen bɛɛ bɛ se ka baara kɛ ni o ye sanga 1 ɲɔgɔn.
